Search results

View (previous 20 | ) (20 | 50 | 100 | 250 | 500)
  • Thumbnail for Axle
    the axle. Sometimes, especially on bicycles, the latter type of axle is referred to as a spindle. On cars and trucks, several senses of the word axle occur...
    14 KB (2,005 words) - 12:43, 27 December 2023
  • Thumbnail for Spindle (automobile)
    In an automobile, the wheel spindle, sometimes called simply the spindle, is the part of the suspension system that carries the hub for the wheel and attaches...
    2 KB (210 words) - 02:30, 22 December 2023
  • of an axle, short in shape and blunt. There are four general designs: Elliot axle Reversed Elliot axle Lemoine axle Inverted Lemoine axle Spindle (automobile)...
    774 bytes (114 words) - 20:13, 13 April 2023
  • Thumbnail for Bottom bracket
    the spindle and bearings; the term is now used for all frames, bracketed or not. There is some disagreement as to whether the word axle or spindle should...
    43 KB (5,040 words) - 15:37, 23 April 2024
  • involved several modifications to the front-axle assembly. The front axle assembly of a wagon consists of an axle, a pair of wheels and a round plate with...
    3 KB (329 words) - 09:51, 24 April 2024
  • shock absorbers, cylinders and rods for hydraulic systems, pumps, axles, spindles, firearm slides and barrels and valves. The process starts with a standard...
    4 KB (375 words) - 03:29, 28 April 2024
  • Thumbnail for Tandem bicycle
    for the advantage of a similar decrease in the bending moment of the axle spindle. Rear hubs may also be threaded on the left side to allow the use of...
    25 KB (3,127 words) - 21:40, 13 May 2024
  • Thumbnail for Wheel
    axle bearing. The wheel is one of the key components of the wheel and axle which is one of the six simple machines. Wheels, in conjunction with axles...
    44 KB (4,936 words) - 04:50, 1 May 2024
  • base that contains the mechanism. The brake shield is mounted on an axle/spindle using the holes in the centre. The brake shoes (3) are the items performing...
    7 KB (1,066 words) - 13:12, 20 October 2021
  • Thumbnail for Dana 50
    Dana 50 (category Automobile axles)
    TTB Dana 50, than a F-350 with a solid axle. The GAWR of a TTB Dana 50 was 4600 lbs. The Dana 50 TTB spindles will accept the Dana 60 hubs however the...
    3 KB (433 words) - 15:49, 10 January 2024
  • Thumbnail for List of bicycle parts
    catching in the wheel, or in the gap between the rim and the brakes Spindle: an axle around which a pedal rotates; threaded at one end to screw into crank...
    17 KB (2,410 words) - 17:46, 9 December 2023
  • Thumbnail for Torsion bar suspension
    perpendicular to the bar, that is attached to a suspension arm, a spindle, or the axle. Vertical motion of the wheel causes the bar to twist around its...
    18 KB (2,450 words) - 18:40, 21 April 2024
  • Thumbnail for Ship's wheel
    wheel was connected to the other with a wooden spindle that ran through a barrel or drum. The spindle was held up by two pedestals that rested on a wooden...
    6 KB (824 words) - 17:25, 2 May 2024
  • Thumbnail for Tachometer
    connected by an axle to a rotating magnet that induces a changing magnetic field upon a Hall effect transistor. Other systems connect the spindle to a stroboscope...
    14 KB (1,829 words) - 14:42, 30 October 2023
  • Thumbnail for Crankset
    length is measured from the center of the pedal spindle to the center of the bottom bracket spindle or axle. The larger bicycle component manufacturers typically...
    38 KB (5,158 words) - 03:01, 21 April 2024
  • Thumbnail for Bobbin
    A bobbin or spool is a spindle or cylinder, with or without flanges, on which yarn, thread, wire, tape or film is wound.[full citation needed] Bobbins...
    10 KB (1,144 words) - 23:52, 14 November 2023
  • Thumbnail for Double wishbone suspension
    classified as short spindle, in which the upper ball joint on the spindle is inside the wheel, or long spindle, in which the spindle tucks around the tire...
    10 KB (1,402 words) - 21:24, 11 April 2024
  • Thumbnail for Cannone da 47/32
    projects were soon abandoned as the gun was subjected to breaking at the axles spindles and shanks. Due to its shape, the 47/32 was commonly called "elefantino"...
    8 KB (808 words) - 05:39, 2 January 2024
  • Thumbnail for Lathe
    horizontal axle, with an axis parallel to the bed, called the spindle. Spindles are often hollow and have an interior Morse taper on the spindle nose (i...
    42 KB (5,702 words) - 19:12, 4 May 2024
  • shafts are the integral part of the machine itself; e.g. crankshaft. Axle shaft. Spindle shaft. The material used for ordinary shafts is mild steel. When...
    2 KB (281 words) - 10:07, 29 February 2024
View (previous 20 | ) (20 | 50 | 100 | 250 | 500)